When a network filter fails, it must be replaced

[shapanwwuom]

Rewinding the engine is sometimes even more expensive than buying the part. To determine whether the lamellas are worn out, you need to inspect the collector. When burrs appear on their surface, contacts break or delamination is observed, sparks appear.

As a result, the engine overheats. If the wires break, it is almost impossible to put them back in place. Upon closer inspection of the engine, it may turn out that the anchor is touching the stator. Experts advise replacing both elements.

Often the user has to deal with a situation when the drum rotates too slowly or does not rotate at all. This is a consequence of a short circuit that occurred between the turns in the winding. The reason could be overheating of the motor housing, which is why the thermostat worked.

The temperature at which the electric motor should operate canada telegram data should not exceed 80 C. To check this assumption, it is necessary to use a tester. It is connected to the lamellas. The resistance should be in the range of 0.1-0.4 Ohm. The cause of a short circuit is often a violation of the integrity of the winding.

Network filter
There is no point in repairing it. However, experts remind that even a new filter may not work for long, even if there were no large voltage surges in the network. The main reason for the malfunction is not a surge, but the accumulation of condensate , which causes a short circuit. There is a way to extend the life of the described part. To do this, its contacts must be cleaned, and then thoroughly wiped with a rag and additionally filled with silicone-based sealant.

Hatch cover locking device
If the lock of the locking lid breaks, the washing machine simply will not turn on, since the system does not receive a signal about the tightness of the door. The manufacturer has thought out the design of the locking device in such a way that there are contacts at its ends. If they are open, then there is no power to the motor.